Abstract:
|
Research results of forming LF6 alloy conical tube with half cone angle less than one degree are described in this paper.The forming scheme which utilize slab blank, straight and small coning mandrels, conventional spinning and power spinning is adopted. Firstly, blank is deformed into cylinder with hot conventional spinning in straight mandrel.Then thick-walled tube is forcedly thinned at room temperature after cylinder bottom is cut off. Finally, small coning mandrel and hot conventional spinning are adapted to form conical tube. It can be shown from the results that the ensured blank's high quality before spinning is required to avoid local defect and temperature must be well controlled at hot spinning. LF6 alloy has a good spinning performance. Selecting reasonable technological parameters, seamless conical tube of LF6 alloy with half cone angle less than one degree can be formed by spinning with blank.
|
Funds:
|
|
AuthorIntro:
|
|
Reference:
|
[1]赵云豪.角度锥形筒体旋压成形实验研究[C].全国第九届旋压技术交流大会论文集.2002,9:8688.
[2]徐骏,李亚丽,赵云豪.LF6铝合金厚壁简体强力旋压工艺的研究[J].铝加工,1999,22(4):3638.
[3]赵云豪,徐小云.LF6筒形件强力旋压成形[J].金属成形工艺,1990,(4):14.
[4]王振生.变薄旋压产品常见缺陷探讨[J].金属成形工艺,1999,17(2):3133.
[5]王成和,刘克璋.旋压技术[M].北京:机械工业出版社,1986.
[6]陈适先,贾文铎,等.强力旋压工艺及设备[M].北京:国防工业出版社,1986.
|
Service:
|
【This site has not yet opened Download Service】【Add
Favorite】
|
|
|