|
Abstract：
|
|
Based on the elastic-plasticity theory of sheet forming and Dynaform software,the drawing process of the BoraA5's engine hook exterior panel was studied,and the drawing parameters and mould parameters were designed by the use of orthogonal experiment method.The effects of binder force,stamping speed,draw-bead depth and the gap between punch and die on wrinkle and crack when the exterior panel was drawn were studied.The results show that in forming the exterior panel,the impact of binder force and the stamping speed on the minimum local thickness is greater and the impact of the gap between punch and die and draw-bead depth on the minimum local thickness is smaller.That is the greater the binder force,the smaller the minimum local thickness;the greater the stamping speed,the smaller the minimum local thickness.According to numerical simulation,the reasons for wrinkle and crack were comprehensively analyzed,and the corresponding solution of drawing quality was given.The drawing scheme was applied to the real technology design and die manufacture.The results show that the simulation result fits with the actual forming process very well.
|
|
Funds：
|
|
|
|
AuthorIntro：
|
|
|
|
Reference：
|
[1]林忠钦.车身覆盖件冲压成形仿真[M].北京:机械工业出版社,2004.
[2]赵侠,傅建,余玲,等.数值模拟技术在汽车覆盖件成形中的应用[J].锻压技术,2006,31(1):15-17.
[3]王晓路,陈炜,高霖,等.数值模拟对薄板冲压成形工艺设计的优化[J].锻压技术,2005,30(3):21-23.
[4]黄荣学,曹建国,范洪远.有限元法在冲压模具分析中的应用及展望[J].锻压技术,2005,30(2):69-71.
[5]Engineering Technology Associates,Inc.Dynaform-PC Ap-plications Manual[Z].1999.
[6]郝行舟,李春生.正交试验设计方法在试验设计中的应用[J].河南交通科技,1999,19(6):26-28.
|
|
Service：
|
|
【This site has not yet opened Download Service】【Add
Favorite】
|
|
|
|
Copyright Forging & Stamping Technology.All rights reserved