Abstract:
|
First,the application status and the analytical methods of tube hydro-forming technology were introduced,and then the friction mechanism between tube blank and mold was analysed.Based on the numerical analysis and experimental study,the influence of lubricating condition on the tube hydro-forming process parameters,such as axial feeding,thickness distribution of automobile instrument panel beam,was discussed.Finally,the results provide the theoretical references on the determination of feeding amount,selection of lubricating schemes and molds design during actual manufacture.
|
Funds:
|
安徽省教育厅高等学校青年教师科研资助计划(2007JQ1043)
|
AuthorIntro:
|
|
Reference:
|
[1]Jirathearanat S.Advanced methods for finite element simula-tion for part and process design in tube hydroforming[D].Dissertation:Ohio State University,2004.
[2]何祝斌,滕步刚,苑士剑,等.管材轴压液力成形中的摩擦与密封[J].锻压技术,2001,27(3):38-40.
[3]郭力,李光耀.薄板成形计算机仿真中摩擦模型的研究进展[J].中国机械工程,2003,14(21):1879-1882.
[4]Altan T,Ngaile G.Improvement of tribological conditions intube hydrofroming[R].ERC/NSM Report,Ohio State Uni-versity.
[5]Costello M T,Riff I I.Study of hydroforming lubricants withoverbased sulfonates and friction modifiers[J].TribologyLetters,2005,(20):2001-2008.
[6]Gracious Ngaile,Stefan Jaeger,Taylan Altan.Lubrication intube hydroforming(THF)-Part II:Performance evaluation oflubricants using LDH test and pear-shaped tube expansion test[J].Journal of Materials Processing Technology,2004,(146):116-123.
[7]郑再象.汽车用异型截面管件液压成形设备及工艺参数研究[D].江苏:南京理工大学,2007.
|
Service:
|
【This site has not yet opened Download Service】【Add
Favorite】
|
|
|