Abstract:
|
The cupping test and forming limit test were done for the tailor welded blanks(TWBs)of different thicknesses.The results show that wrinkles and cracks almost occur in the thinner side,which indicates that the strength of the welding-line increases but the deformation resistance of that position decreases.Moreover,DYNAFORM software was used to simulate the formability of the front floor part.From the simulation,the thinner side of the TWBs possessed the bigger area and the weld-line did not remove,but the possible cracks and the maximum thinning positions always occured at the thinner side.So it is important to make formability analysis of the weld-line while analyzing the part made of TWBs.
|
Funds:
|
吉林大学985工程项目资助和吉林省汽车产业化专项项目
|
AuthorIntro:
|
|
Reference:
|
[1]Anand,Chen,Bhole,et al.Fatigue behavior of tailor(la-ser)-welded blanks for automotive applications[J].Materi-als Science and Engineering,2006,420(1):199-207.
[2]Kinsey,Brad,Liu Zhihong,et al.Novel forming technolo-gy for tailor-welded blanks[J].Journal of Materials Process-ing Technolog,2000,99(1):145-153.
[3]张士宏,许沂,王忠堂,等.拼焊板材冲压成形技术(Ⅱ)[J].金属成形工艺,2001,19(5):1-7.
[4]张士宏,程欣,郎利辉,等.不等厚拼焊板的塑性拉伸变形性能试验分析[J].金属成形工艺,2000,18(6):10-13.
[5]阎启,俞宁峰.激光拼焊板成形极限图性能分析[J].机械工程材料,2005,29(5):37-40.
[6]Scott D Raymond,Pater M Wild,Christopher J Bayleg.Onmodeling of the weld line in finite element analyses of tailor-welded blanks forming operations[J].Journal of MaterialsProcessing Technology,2004,147(1):28-37.
[7]翁孟超,杨志强,涂新军.基于Dynaform的拼焊板冲压成形压边方法研究[J].锻压技术,2007,32(2):33-36.
|
Service:
|
【This site has not yet opened Download Service】【Add
Favorite】
|
|
|