Abstract:
|
In view of the crack problems easily occurring in the conventional cylindrical deep drawing process due to the lower formability of aluminum alloy sheet,the method involving pre-forming by conventional deep drawing and re-deformation by electromagnetic forming was designated and performed for experimental investigations on the formability problems of cylindrical parts deformed by 5052-O aluminum alloy sheet.And the efficacy of enhanced formability for aluminum alloy using this method and the feasibility of decreasing corner radius by electromagnetic forming were discussed.Results show that electromagnetically assisted sheet metal stamping(EMAS) can significantly improve the formability of aluminum alloy sheet compared with conventional stamping process.With the increment of discharge voltage and discharge times,the re-deformation ability of bottom corner of cylindrical part can be remarkably enhanced.The most severe reduction region is existing at the joint of the side wall and bottom corner in conventional deep drawing process,while in EMAS of aluminum alloy cylindrical part,there exist two severe reduction regions: the joint of the side wall and bottom corner and the joint of the bottom and corner region.
|
Funds:
|
国家自然科学基金资助项目(50575052)
|
AuthorIntro:
|
|
Reference:
|
[1]Satio M,Iwatsuki S,Yasunaga K.Development of aluminumbody for the most fuel efficient vehicle[J].JSAE Review,2000,21(1):511-516.
[2]Okoye C N,Jiang J H,Hu Z D.Application of electromag-netic-assisted stamping technique in incremental sheet metalforming[J].International Journal of Machine Tools&Man-ufacture,2006,46:1248-1252.
[3]Vohnout Vincent J.A hybrid quasi-static/dynamic processfor forming large sheet metal parts from aluminum alloys[D].Ohio:Graduate School of the Ohio State University,1998.
[4]李春峰,于海平,刘大海.铝合金磁脉冲辅助板材冲压技术研究进展[J].中国机械工程,2008,19(1):108-113.
[5]陆辛,费仁元,初红艳.复合冲压技术发展前景[J].锻压技术,2001,26(6)23-25.
[6]Seth M,Vohnout VJ,Daehn G S.Formability of steel sheetin high velocity i mpact[J].Journal of Materials ProceedingTechnology,2005,(168):390-400.
[7]Vohnout V J,Daehn G S.Reducing stamped part develop-ment ti me with pulsed energy assistance[EB/OL].http:∥www.osu.edu/hyperplasticity,2004.
[8]Shang J H.Electromagnetically assisted sheet metal stamping[D].Ohio:Ohio State University,2006.
[9]Neugebauer R,Loschmann F,Putz M,et al.A production-oriented approachin Electromagnetic forming of metal sheets[A].Kleiner M.Proceedings of 2nd International Conferenceon High Speed Forming[C].Dort mund,2006.
[10]Dehra M S.High velocity formability and factors affecting it[D].Ohio:Graduate School of the Ohio State University,2006.
|
Service:
|
【This site has not yet opened Download Service】【Add
Favorite】
|
|
|